ESP8266-03 WiFi Module (ESP-03)

The ESP8266 is a highly integrated chip tailored to meet the demands of a progressively interconnected world. It provides a comprehensive, autonomous Wi-Fi networking solution, allowing it to either host an application or delegate all Wi-Fi networking tasks to another application processor. The ESP8266, with its robust onboard processing and storage capabilities, can seamlessly integrate with sensors and other application-specific devices via its GPIOs, requiring minimal development effort and runtime loading. Its high level of on-chip integration necessitates minimal external circuitry, thus saving valuable PCB space.

Features:

• SDIO 2.0, SPI, UART interfaces
• 32-pin QFN package
• Integrated RF switch, balun, 24dBm PA, DCXO, and PMU
• Integrated RISC processor, on-chip memory, and external memory interfaces
• Integrated baseband processors
• Quality of Service management
• I2S interface for high-fidelity audio applications
• On-chip low-dropout linear regulators for all internal supplies
• Proprietary spurious-free clock generation architecture
• Integrated WEP, TKIP, AES, and WAPI engines
• Supports APSD for optimal VoIP applications
• Patented spurious noise cancellation algorithm
• Supports Bluetooth coexistence interface
• Self-calibrated RF for optimal performance
• No external RF components required

Specifications:

• 802.11 b/g/n support
• Wi-Fi Direct (P2P), soft-AP mode
• Integrated TCP/IP protocol stack
• Integrated TR switch, balun, LNA, power amplifier, and matching network
• Integrated PLLs, regulators, DCXO, and power management units
• +19.5dBm output power in 802.11b mode
• Power down leakage current < 10uA
• Integrated low-power 32-bit CPU
• SDIO 1.1/2.0, SPI, UART interfaces
• STBC, 1x1 MIMO, 2x1 MIMO support
• A-MPDU & A-MSDU aggregation & 0.4ms guard interval
• Wake up and transmit packets in < 2ms
• Standby power consumption < 1.0mW (DTIM3)

Additional Information:

• High quality & low price
• LWIP protocol support
• Supports 3 modes: AP, STA, AP+STA
• Simple AT commands for configuration
• Ideal for your upcoming Internet of Things project, home automation, or remote sensor application. This module adapts the ESP8266 IC for use over a serial connection using simple AT commands, thereby eliminating the need for SPI interface or extensive technical expertise.

Warning:

This module requires a 3.3V supply for VCC and 3.3V logic levels. It is not 5V tolerant. Connecting RX or TX to 5V will damage the module. You must use a logic level converter or a 3.3V Arduino board. The 3.3V supply on the Arduino Uno may not provide sufficient current. Use a separate 3.3V power supply (about 300mA or better). Support and documentation for this module may be limited as it is relatively new on the market.